Hager Perfect Splint System

• Cutable plastic (PET ) or stainless steel nets for splinting
• Each pack sufficient for the splinting of approx. 200 teeth
• Length: 90 mm, Wide: 5 mm

Instructions for Use

Affixation

• Cut the Perfect-Splint net to the desired length. Cut V-shapes along the gingival margin side to match the interproximal area.
• Clean the teeth to be splinted with cleaning paste and etch the the palatinal or lingual glued surface with a phosphoric acid medium, such as Micro-Etch.
• Place the orthodontical wire (cut into approx. 5 cm pieces) interproximally along the prepared teeth.
• Apply a thin layer of composite to the entire etched tooth surface.
• Place a small amount of a f lowable composite in the center of the palatinal or lingual surface of the tooth. Start with the first tooth to be splinted.
• Push the prepared Perfect-Splint net to the tooth with an instrument, e.g. an amalgam condensor. The material should pour through the mesh. If this does not happen, apply more of a flowable composite to the mesh.
• Allow the composite to cure.
• Lead the orthodontical wire over the net to the labial side and pull it with both ends of the wire into the approximal area. Repeat
• procedure from point 5.
• Remove the wires and completely cover the Perfect-Splint net with a composite material

Areas of application:

• traumatically or periodontically loosened teeth
• transplanted, implanted under replanted teeth
• before and after surgical procedures
• diastema closures
• orthodontical procedures

Recommendation: intraoral use not longer than 30 day

Removal

• Place the Desmoclean instrument in the green, slowly rotating contra angle hand piece and loosen the mesh interdentally between the teeth that were splinted last.
• When the net is ripped, it can be removed palatinally or lingually with Desmoclean - with light pressure and water spray.
• Once the mesh is removed and the etched enamel smoothed, a sealing of the area is recom-men-ded in order to prevent the development of caries.
• The gingiva calms down quickly by applying the Myzotect-Tincture or Miradont Gel.
• Perfect-Splint-System is a disposable product. It was not designed to be re-used. Sterilizing it could have a negative impact on the product features. Re-use of the article causes a high risk of infection.

Other instruments, such as finishers, may also be employed. The Desmoclean provides for a fast and easy removal while preventing damage to the enamel. Tartar that could not be removed during the wear of a splint can be eliminated at the same time and without instrument change.

Warning

Perfect Splint C is a disposable product. It was not designed to be re-used. Sterilizing it could have a negative impact on the product features. Re-use of the article causes a high risk of infection.