D-Tech XT Etch

D Tech Dental Technologies 61Reality Warehousing Gat No 13371 Pune Nagar Road Wagholi Pune 412207 India

Clean the Tooth Surface: Begin by cleaning the area to be etched to remove any debris or plaque.

Isolate the Area: Use a rubber dam or cotton rolls to isolate the tooth and ensure a dry working field.

Apply Etching Gel: Remove the syringe cap and attach a dispensing tip. Apply a thin layer of D-Tech Etching Gel directly to the enamel or dentin surface.

Etching Time:

Enamel: Leave the gel in place for 15-20 seconds.

Dentin: Limit exposure to 10-15 seconds to avoid over etching.

Rinse Thoroughly: Use water spray to rinse off the gel completely for at least 15 seconds.

Dry the Surface: Gently air-dry the area. The enamel should appear frosty white. Avoid overdrying dentin.

Proceed with Bonding: Continue with the application of primer, adhesive, or restoration as per the procedural protocol.

• Etching of enamel and dentin surfaces prior to the application of bonding agents, sealants, or composite restorations

• Preparation of tooth surfaces for adhesive cementation

• Suitable for both direct and indirect restorative procedures

• Used in cavity preparations to enhance micromechanical retention

• XT Extra Thixotropic  - Gel stays exactly where placed, minimizing flow and mess.

• 37% Phosphoric Acid  - Ensures effective etching of enamel and dentin.

• Bright Blue Color - Highly visible for precise application.

• Homogenous Gel - No separation; consistent texture throughout.

• Excellent Water Solubility - Easy rinsing, leaving no residue behind.