Melag Vacuklav 23 B Plus (B-Class) - 22 Ltr
- Buy 2 for ₹366923 each and save 3%
The Vacuklav 23 B+ is a ”class B" autoclave according to the European standard EN 13060 and therefore absolutely fit for the future. It works according to the fractionated pre-vacuum method. This means that at first the air is evacuated from the chamber with a very effective vacuum pump. Then there is a repeated intake of steam which is always immediately pumped out again. The result is that at the beginning of the actual sterilization, there is no longer any air in the chamber or in wrapped hollow-instruments or in textiles which would endanger the success of the sterilization.
The Vacuklav is equipped with a fractionated post vacuum for effective drying as a prerequisite for long-term storage of packaged sterilized materials. Sensors and an innovative microprocessor control regulate and monitor the parameters necessary for a secure sterilization pressure and temperature.
Thanks to the patented air-cooling system, the Vacuklav 23 B+ is a real "stand-alone" autoclave. Only a socket is necessary for operation. The strong vacuum pump and the efficient steam generator provide short cycle times so that simply wrapped hollow-instruments operated in the Quick-Program B can be taken out dry after only 25 minutes. The integrated monitoring of the feed water and the electronic control of the Vacuklav 23 B+ avoid operating faults and secure high-quality sterilization and maximum gentleness for your instruments
|Chamber Depth||25 cm|
|Chamber Height||45 cm|
|Chamber Volume||22 L|
|Length 72 cm||72 cm|
|Tray||Width: 19 cm x Depth: 42 cm x Height: 2 cm|
- “Stand alone” device
- High quality sterilization
- No need of any further installation
- Class B- highest class in autoclave
- Can connect to the MELAflash CF Card Printer
- Automatic supply of demineralized water & drain of the used water
- Manufacturer/Importer warranty of 12 Months applicable for this product.
- Service and Warranty are handled by the manufacturer/importer directly for this product.
- PinkBlue will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer.
- PinkBlue and the Buyer acknowledge that the Products purchased/used are a subject matter of original Manufacturer/Importer’s warranties.
- Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and not PinkBlue.
- However, PinkBlue may assist the customer in lodging a complaint to get the Product replaced or serviced.
- The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact.